Tramline Automation for FS25
This is my first script mod for FS25. Since the tramlines from Precision Farming did not always convince me. It automatically integrates into all implements that can be used as seeders.
The HUD can be controlled with the mouse, which can be activated via an assigned key.

Set Tramline Distance:
Here you set the working width of the sprayer or fertilizer spreader.
This can either be adjusted using two assigned keys or by clicking the plus and minus buttons with the mouse.

Rhythm:
Here you can see the number of passes required for one working width of the sprayer or fertilizer spreader.
In manual mode, the current pass can be adjusted with + and – if necessary.
I would like to reference a PDF by Webalizer, who created ProSeed for LS17.
There you can look at the tramline distances:
https://webalizer-gt.github.io/ProSeed17/images/ProSeed.pdf
The half pass should only be done on the second pass.
If you are using GPS and a half pass is required, it should look like this:
First pass normal. Starting from the second pass, set an offset of half the working width in the GPS menu. See the description further below under GPS Offset Mode.

Mode:
The active working mode of the tramline automation can be changed either via an assigned key or with the mouse by clicking on the selected mode.
Pause:
No tramlines will be created.
The counter is paused.

Always:
Tramlines are always active when the implement is lowered.

GPS:
Automatic track detection via GIANTS Steering Assist.
At the beginning, a reference track must be set. This can be done using an assigned key.

Manual:
Counting is done by raising/lowering the implement.
The symbol behind it indicates whether a tramline is currently being created or not.

GPS Offset:
Requirement: GPS mode
Since with an even rhythm number you must work with half the working width on the first pass, you can set the offset so the track does not start jumping.
This value can either be adjusted via an assigned key or with the mouse using the + and – buttons next to the rhythm.
In GPS mode, these buttons are repurposed to increase or decrease the GPS offset.

Track Width:
Here you can see the configured tramline track width.
This can be adjusted with two assigned keys or by clicking the plus and minus buttons with the mouse to match the track width of the crop care tractor, because smaller tractors have a narrower track width than larger tractors.

Buttons:
Tramline distance +/-: Increase or decrease the tramline spacing
CURSOR ON/OFF: Show or hide the mouse pointer
Tramline Mode switch: Switch the tramline mode
GPS reference Lane set: Sets the GPS reference track
reference -½ lane or reference +½ lane: Move the GPS reference track half the working width to the right or left
Track width +/-: Adjusts the track width from 1m to 6m